If you need to convert a Hawk from multifuel to wood you would need to;
1) Open the stove door and remove the ash pan.
2) Remove the riddling bars by lifting off the cam bar and removing.
3) Remove cam bar by lifting the left hand side and sliding cam bar out of position.
4) Remove the catch bar as shown.
5) Remove the side plates by sliding them away from the side brick and removing fully.
6) Remove both side fire bricks by tilting towards the centre and lifting out.
7) Remove the rear brick by tilting the top forward and carefully lifting the brick out.
8) Remove the rear brick support bracket by undoing the two fixing bolts shown. Refit
the bolts from outside the stove to seal up the bolt holes. Do not wind them in so far
that they protrude into the firebox.
9) Position cam bar hole plug and fasten using nut and washer.
10) Fit the wood burning rear brick shown.
11) Re-fit the side bricks in the position shown.
12) Fit wood burning catch bar as shown and close the stove door.