To install a Non Eco Aspect multifuel kit you will need to;
Remove the current log retainer.
2. Remove the bottom base brick by lifting
up on one side and slide out of body of
stove.
3. Remove the both the side bricks, taking
care not to disturb the top rear bricks.
Pull top inwards and then remove the
brick from the stove.
4. Remove the brick or steel baffle.
5. Remove both the bottom rear bricks
by pushing the brick upwards.
Then pull the bottom edge of the rear
brick forward and lift the brick out of
stove. Repeat with other brick.
FITTING THE MULTIFUEL KIT
1) Refit both side bricks.
2) Fit the front grate support by
dropping in place.
3) Side plate front.
4) Offer the side plate into the stove,
fitting into the front grate
support and slide into place.
5) Lower the back edge of the grate onto
the side and front supports and slide
backwards. When fitted the grate will
lie flat.
6) Slide the ash pan in under the front
support.
7) Place the new log retainer onto
the pins.